Hard drawn bus bar with high thermal and electrical conductivity. Good resistance and tampering. Not suitable for case hardening.
Applications
Copper No. 11000 is used for welding fixtures, anodes, bus bar in electrical power installations, ground straps, commutators, etc. Its inherent fabrication qualities readily permit it to be bent, soldered, drilled, peened, riveted and formed to fit almost any design specification.
Mechanical Properties
Typical for 1" solid diameter Hard (35%) Temper
Hardness*
Rockwell F Scales
87
Tensile Strength**
KSI
48
Yield Strength **
KSI
44
Elongation**
% in 2 inch
10
*Hardness conversions are approximate
**Test values are nominal approximations and depend on specimen size and orientation.
Physical Properties
Thermal Conductivity
BTU/ (sq ft-ft-hr-F)
226
Specific Heat
BTU/lb/ºF @ 68F
.092
Thermal Expansion
Per °F from 68 F to 212 F
.0000094
Density
lb/cu in @ 68 F
.321-.323
Electrical Conductivity
% IACS @ 68 F
101
Modulus of Elasticity
KSI
17,000
*Volume basis
Fabrication Practices
Capacity for being cold worked
Excellent
Capacity for being hot formed
Excellent
Hot forgeability rating (forging brass=100)
65
Hot working temperature
1400-1600 F or 750-875 C
Annealing temperature
700-1200 F or 375-650 C
Machinability rating (Free Cutting Brass=100)
20
Suitability for being joined by:
Soldering/Excellent
Brazing/Good
Oxyacetylene Welding/Not Recommended
Gas Shielded Arc Welding/Fair
Coated Metal Arc Welding/Not Recommended
Resistance Welding
Spot/Not Recommended
Seam/Not Recommended
Butt/Good
The values listed above represent reasonable approximations suitable for general engineering use. Due to commercial variations in composition and to manufacturing limitations, they should not be used for specification purposes. See applicable A.S.T.M. specification references.
Please contact us for all your needs of
C11000 Electrolytic Copper
at best prices from India. We are the biggest foundry casting alloy indian manufacturers exporters foundries in Jamnagar of
Copper Alloy No. C11000 
